PenDraw Pipe Development Demonstration
 
PenDraw runs Server-side in this demo.
What happens here is that you define thediameter of two pipes.
The first one is the mainpipe. The second one is a pipe that joins the first pipe.

You also specify the angle between them.
PenDraw then calculates the line of intersection, and what
the second pipe would look like if you drew it out flat.

You can try this.
You can print it out, and cut out the paper with scissors.
The pipes really will join up.

To use:-
  1. Edit the Plate parameters, below.
  2. Hit the Calculate and Draw button, and see.
Pipe 1 Diameter (between 1 and 30)
Pipe 2 Diameter (between 1 and 30)
Angle of Intersection (degrees, greater than 45)
  
Pipe 1 diameter must be bigger then pipe 2.
If it isn't, PenDraw will swap their diameters